RTL Reference

Blocking = and Nonblocking <=

A blocking assignment updates at once. A nonblocking assignment reads now and updates at the end of the time step.

Syntax

a = b;    // blocking: a changes before the next statement
a <= b;   // nonblocking: a changes after every right-hand side is read

Rules

  • Use <= for flops, in always_ff.
  • Use = for combinational logic, in always_comb.
  • Do not mix both kinds for one variable.
  • With <=, the order of the statements does not change the result.

Example

module tb;
  logic clk = 0;
  logic [3:0] a = 1, b = 2;   // swapped with <=
  logic [3:0] c = 1, d = 2;   // "swapped" with =

  always @(posedge clk) begin
    a <= b;
    b <= a;
  end

  always @(posedge clk) begin
    c = d;
    d = c;
  end

  initial begin
    #1 clk = 1; #1;
    $display("nonblocking: a=%0d b=%0d", a, b);
    $display("blocking:    c=%0d d=%0d", c, d);
  end
endmodule
Output on Icarus Verilog 12
nonblocking: a=2 b=1
blocking:    c=2 d=2

Run It in the Playground

Common Mistake

Reading a flop that another block wrote with =

always @(posedge clk) q1 = d;
always @(posedge clk) q2 = q1;   // old q1 or new q1?

Both blocks run on the same edge, in an order the standard does not fix. q2 can get either value, and two simulators can disagree.

Fix: Use <= in both blocks. q2 then always gets the old q1.

Learn It Properly

These lessons teach it step by step, with practice problems.

Standard

IEEE 1800-2023, 10.4.1 and 10.4.2.